Careand Cleaning; To Clean Individual Components; To Clean Without Disassembly - KitchenAid KSB655 Instructions Manual

Care and Cleaning
The Blender pitcher, accessory jar, locking
collar and blade assembly can be easily
cleaned as individual components or
together without disassembly.
° Clean the Blender thoroughly after
every use
° Do not immerse the Blender base or
cord in water
° Do not use abrasive cleansers or
scouring pads
To Clean Individual Components
1. Lift the pitcher or accessory jar
assembly in a straight, upwards motion
off the Blender base. Then, while
holding locking collar, rotate pitcher
or accessory jar counterclockwise, two
clicks, to separate locking collar and
blade assembly, and sealing ring from
the pitcher or accessory jar. Wash
components with soapy water. Rinse
and wipe dry.
NOTE: Pitcher can be placed in the
bottom rack of an automatic dishwasher.
The accessory jar, both lid(s), ingredient
cup, drizzle cap, locking collar and blade
assembly, and sealing ring can be put
in the top rack. For best results, hand
washing is recommended.
To
1.
2.
3.
Clean Without Disassembly
Put the pitcher or accessory jar on the
Blender base, fill half full with warm
(not hot) water, and add 1 or 2 drops
/
of dishwashing liquid. Put the lid
on the pitcher or accessory jar, press
the STIR speed setting, and run the
Blender for 5 to 10 seconds. Remove
the pitcher or accessory jar and empty
contents. Rinse with warm water
until clean.
To clean the lid(s), ingredient cup and
drizzle cap, wash in warm soapy water,
then rinse and dry thoroughly.
Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
Pitcher --
Sealing
Ring
Locking
and Blade
Assembly
2. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
13