THE DRYER DOOR iS VERY LARGE AND HEAVY. Failure to follow the instructions
below can result in damage
the dryer, property
Open the door and remove the two plastic hole
caps on the catch side by gently prying up with a
fiat blade screwdriver.
Save these for step 6.
Be sure to support the weight of the
door before removing the hinge screws.
the door, remove the four
screws, two from each hinge. Set the door aside
face down on a protected
surface to prevent
to the door or the work surface.
Remove the four
the hinges to the
door frame. Remove the two plastic cover caps on
the side opposite the hinges. Reinstall the hinges
and cover caps on the opposite
sides from which
they were removed.
i, m m,J
_, m m ,J
locations, remount the inner door frame onto the
outer door frame with the screws removed in step
Reinstall the door with the screws from step 2, and
snap the hole caps into the open hinge mounting holes.
on a protected
16 screws on each side of the door and lift off the
inner door frame using a fiat blade screwdriver.
Remove the latch hook and blank and move them
to the opposite side.
the swing of the door to make sure the hinges
and latch are properly
and that the door
closes and latches.