Fault Codes - Frigidaire LRA107CV113 Use & Care Manual

Operating Instructions
(continued)
TIMER: DELAY STOP / START FEATURE
[
m cool
econ
Ion only
temp/timer
Hr
timer MODE
ON=OFF
YOU WILL SEE HOW MUCH TIME IS CHOSEN:
temp/timer
B COOl econ
fan only Hr
m
timer NODE V ON-OFF A
FI RST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( V ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected). The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
CHECK FILTER FEATUREr YOU WILL SEE;
temp/timer
auto
] m
hi . fitter med
lo reset
V ON-OFF A FAN SPEED steep
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
FAULT CODES;
v
temp/timer
ON=OFF
auto 1
hi m f_ [ter
med I reset
A FAN SPEEDii/_steep
/
Do T.,S:/ I
PRESS FILTER
RESET BUTTON
temp,/timer
auto ]
hi = fitter reed
lo reset
V 0N-OFF A FAN SPEED steep
If the display reads "AS", a sensor has failed. Contact your
Authorized Frigidaire Service Center.
@2009 Electrolux Home Products, Inc. All rights reserved.