Table of Contents
Advertisement
Effortless
TM
Oven Rack system
Some models are equipped with a special oven rack
system that automatically
partially extends the oven rack
from the interior oven glides to assist in easier access to
your food items. This feature works whenever the oven
door is opened or closed.
Make sure the oven and oven racks are COMPLETLY cool
and safe to touch before attempting to assemble or
disassemble the Effortless
TM
Oven Rack system.
Never
REMOVE ALL OVEN RACKS and accessories
before starting
a self-clean
cycle. If the oven racks
are left in the oven during the self-clean cycle, the
glide ability of the Effortless
TM
Oven Rack system will be
damaged and will cause oven racks to loose their shiny
finish and or turn blue. Remove ALL oven racks and
clean according to instructions provided in the Care &
Cleaning section of this manual.
To assemble the Effortless TM Oven Rack system:
1.
Locate all required parts. You will need the supplied
oven rack (Effortless
TM
Oven Rack is a flat rack with a
special dark coating on the left and right rack
sides) and the 2 supplied chrome connector arms.
2.
Open the oven door. Be sure the oven is completely
cool before proceeding.
3.
Place the oven rack in positions 2, 3 or 4 only (see
previous page to verify positions).Be sure the rack
connector brackets are at the rear of the range and
pointing towards oven bottom (See Fig. 2).
4.
Assemble one connector arm at a time. With the oven
door open and the oven rack in place, install one end
of the connector arm to the hole in the door
connector
bracket (Fig. 1) and the other end in the
hole in the rack connector
bracket (Fig. 2 and as in
Fig. 3). The oven rack may need to be adjusted in or
out in the rack position to match the length of the
connector arm.
5.
While holding the connector arm in place, twist the
connector arm so the ends of the connector arm point
upwards
(See Figs. 4 & 5). The connector arm
should now be locked into position.
6.
Repeat steps 4 and 5 for the other connector arm.
7.
Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out
of the oven freely when the door is opened or closed.
Only the Effortless TM Oven Rack system should be
used in oven rack position 2. Placing ANY other rack
in oven rack position 2 will prevent the oven door
from fully closing and may damage the oven door,
oven cavity or the door connector brackets.
If the rack system is not assembled with the connector
arms the Effortless
TM
Oven rack may be used in oven
rack positions 2 thru 6. Do not attempt to use the
Effortless TMOven rack in rack position 1.
door
_. rack connector
connector
bracket
bracket
Fig.
1
-- -
connector
arm
Fig. 3 - assembly
of the Effortless
TM
Oven Rack
open oven
door
oven
rack
connector
arm
connector
\..
arm
eft and right
Fig. 6
brackets
with connector arm en,
shown in locked positior
(pointing
upwards)
Effortless
TM
Oven Rack after assembly
Advertisement
Chapters
Table of Contents
