Frigidaire DGGF3054KFN Use & Care Manual page 32

Removing and replacing the Keep Warm
Drawer
You may remove the Keep Warm Drawer from the range
should it be necessary for cleaning. Carefully follow the
steps below when removing or replacing the Keep Warm
Drawer.
I
Left-hand rail and release
I: 1 Shock Hazard can occur
and result in serious injury or death.
Disconnect appliance from electric
power before cleaning and servicing
the warmer drawer.
To remove Keep Warm Drawer:
1. Turn power OFF before removing the drawer.
2. Open the Keep Warm Drawer completely.
3. On left drawer rail, locate black release lever and press
up with finger while pulling out slightly on the drawer
handle. On right drawer rail, locate black release lever
and press down with finger while pulling out slightly on
the drawer handle (See Fig. 1).
4. The drawer should now be released from the rails.
Carefully remove the Keep Warm Drawer (using level &
square motion) completely away from the appliance.
To replace Keep Warm Drawer:
1. Pull the bearing glides to the front of the outer
compartment glide channels until they snap into place
(refer to Fig. 3).
2. Carefully line up both sides of the Keep Warm Drawer
glide rails to the outer compartment glide channels
located inside the empty drawer compartment (Refer
to Fig. 2).
3. While holding the drawer level and square using the
Keep Warm Drawer handle, push (DO NOT FORCE)
the drawer all the way into the outer compartment
glide channels all the way into the range. Pull the
drawer open again to verify the glides have seated.
4. If you do not hear the levers "click" or the bearing
glides do not feel seated remove the Keep Warm
Drawer and repeat steps "1" through "3". This will
minimize possible damage to the bearing glides.
Keep
Drawer
& handle
Right-hand rail and release
Fig. 1
Fig. 2
I
bearing glide
Fig. 3