Aluminum Foil And Oven Liners; Replacing The Oven Light; The Range - Frigidaire CGEF3055MBB Use & Care Manual

Cooktop cleaning (cont'd)
DO NOT use a cooktop cleaner on a hot cooktop.
The fumes can be hazardous to your health and
can chemically damage the ceramic glass surface.
Do not use the following on the cooktop:
• Do not use abrasive cleaners and scouring pads, such
as metal and some nylon pads. They may scratch the
cooktop, making it more difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach,
ammonia or oven cleaners, as they may etch or discolor
the cooktop.
• Do not use dirty sponges, cloths or paper towels, as
they can leave soil or lint on the cooktop which can
burn and cause discoloration.
Aluminum foil and oven liners (cont'd)
Do not use oven bottom liners or use aluminum foil to
cover the oven bottom or any oven racks.
Using a liner in the
oven restricts the heat
and air flow needed to
obtain the best possible
cooking results for any
oven, including the
warmer drawer (on
some models).
During self-clean the oven temperature can become hot
enough to melt aluminum cooking utensils or aluminum
foil if left in the oven. This could result in damage to the
oven interior porcelain finish.
Replacing the oven light
BLEACH
Be sure the range is unplugged and all parts are COOL
before replacing oven light. Wear a leather-faced glove
for protection against possible broken glass.
The interior oven light is
located at the rear of the
oven interior back wall
and is protected with a
glass shield held by a wire
holder.
glass
wire
holder
The glass shield should
always be in place to
protect and shield the
oven interior light
whenever using the oven.
Aluminum foil and oven liners
• Protective liners--Do not use aluminum foil to line
the oven bottom. Only use aluminum foil as
recommended in this manual. Improper installation of
these liners may result in risk of electric shock, or fire.
To replace the interior oven light:
1. Turn electrical power off at the main source or unplug
the range.
2. While holding the glass shield in place, press wire
holder to one side to release the glass shield.
3. Remove glass shield. Replace bulb with a new 40 watt
appliance bulb.
4. Replace glass shield over bulb and snap wire holder
into place.
5. Turn power back on again at the main source (or plug
the range back in).
6. The clock will need to be reset. To reset review
"Setting the clock" section in this manual.