Electrolux E30IC75FSS5 Service Data Sheet page 2

ELECTRONIC E RROR (FAULT)CODE DESCRiPTiONS
02- LF zone control defective key sensor. 03- LF zone
control defective key sensor. 04- LF zone control key
sensor defective. 06- LR zone control defective key
sensor. 07- LR zone control defective key sensor. 08-
LR zone control key sensor defective.
21- Keep Warm key sensor defective. 22- Timer key
sensor defective. 23- Timer key sensor defective. 24- Lock
key sensor defective. 25- Main power key sensor defective.
31- Internal generator error, sync (4 zones induction
housing / left side cooking zones).
34- Internal generator error, communication (4 zones
induction housing/left side cooking zones).
36- Communication error (4 zones induction housing/
left side cooking zones).
39- Configuration mismatch between the User
Interface and the induction housing.
51- Element temperature sensor break (LF). 52-Element
temp. sensor break (LR). 53- Element temp. sensor
break (RR). 54- Element temp. sensor break (RF).
61- LF element temperature sensor too hot. 62- LR
element temp. sensor too hot. 63- RR element temp.
sensor too hot. 64- RF element temp. sensor too hot.
74- Internal generator error, communication (4 zones
induction housing / right side).
77- Heat sink temperature sensor break (4 zones
induction housing/right side cooking zone).
1) Test cables & connections between left side control and timer.
2) Replace left side Touch Control Board.
3) Replace Center Touch Control
1) Test cables & connections on center touch control.
2) Replace center touch control.
1) Test cables & connections on left side generator board and filter board. 2) Replace
the generator circuit board (left side) in the 4 zones induction housing. 3) Replace the
filter board in the 4 zones induction housinc
1) Check cable between filter board X 12 and generator board X10.2) Replace filter
circuit board in the 4 zones induction housing. 3) Replace generator circuit board in the
4 zones induction housing (left side).
1) Verify all communication cables between user interface and the 4 zones induction
housing. 2) Replace filter board in the 4 zones induction housing. 3) Replace generator
circuit board (left side) in the 4 zones induction housing.
1) To resolve this error, press and hold warm key, then press right front zone ON key until
beep (keep holding WARM) release right front zone on key and press left front zone on key
until beep & config, starts. 2) Replace filter circuit board in the 4 zones induction housing.
1) Verify element temperature sensor is correctly connect to the induction housing. 2)
Replace element if temperature sensor resistor value is not approximately 1000 ohms
(blue wires) at room temperature. 3) Replace associate induction housing.
1) Verify cooktop ventilation is correct (airway & fan). 2) Verify element temp. sensor is
correctly connect to the induction housing. 3) Replace element if temp. sensor resistor
value is not approximately 1000 ohms (blue wires) at room temp. 4) Replace associate
induction housing.
1) Check cable between filter board X13 and generator board X10.2) Replace filter
circuit board in the 4 zones induction housing. 3) Replace generator circuit board in the
4 zones induction housing (right side).
1) Replace generator circuit board (right side) in the 4 zones induction housing.