Download Print this page

Electrolux E30EC65ESS1 Use & Care Manual page 9

Hide thumbs

Advertisement

°ME ELECTRONIC SURFACE ELEMENT CON OL (ESEC/
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
The Electronic Surface Element Control ("ESEC') feature includes 5
digital display windows, The ESEC feature provides a numeric digital
setting for the 5 radiant surface element positions on the cooktop, These
settings work the same way as normal knob setting indicators work
except the settings are displayed in digital windows (Figs, 1 thru 4),
The available
ESEC Display
Settings
The ES EC control provides various heat levels from Hi (Fig, 2) to Lo (Fig,
4) and OFF (Fig, 1), The settings between 9.5 and 3.0 decrease or
increase in increments of,5 (1/2), The settings between 3.0 and ! .2 are
Simmer settings which decrease or increase in increments of ,2 (1/5) to
Lo (Figure 4_ lowest Simmer setting) for more precise settings at lower
heat levels, Use the Recommended Surface Setting Chart to determine
the correct setting for the kind of food you are preparing,
Note: The size and type of cookware used will influence the setting
needed for best cooking results,
LO
OFF
HI
Fig, 1
OFF
HI
Fig. 3
LO
Fig, 2
Fig, 4
ESEC
Power
Failure
Indicator
f_essage
(PF}
When the range is first plugged in or when the power supply to the range has been interrupted,
the ESEC control will display the message "PF" (Power Failure; See Fig, 5), After a few seconds
the "PF" message will disappear from the display,
ESEC Hot Element
Indicator
Message
(HE}
After using any of the single, dual or triple radiant element positions the cooktop will become
very hot. Even after turning the control knob to OFF, the cooktop will remain hot for some time.
The ESEC control monitors the temperatu re of the cooktop and displays the message"H E" (hot
element) warning when the cooktop is still too hot to touch (See Fig.6). if the HE message
appears in the window, the control can still be turned ON again for use.
ESEC Error
Indicator
Message
(Er)
An error message will be displayed (gnowing "E¢') at power up (or after a power failure) if ANY
of the surface control knobs were left in the ON positions (See Fig. 7). if a power failure should
occur, be sure to set all of the surface control knobs to the OFF position. This will reset the
surface controls.
Once the su trace controls have been set to the OFF positions, the surface controls should return
to normal operation, if the surface controls do not function and the"E€' message remains in any
display after following these procedures, contact your authorized servicer for assistance.
Fig. 5
Fig, 6
Fig. 7

Advertisement

loading

  Also See for Electrolux E30EC65ESS1

  Related Manuals for Electrolux E30EC65ESS1

This manual is also suitable for:

E36ec65ess2E30ec65ess3E30ec65ess2E36ec65ess1