Kenmore Power-Mate 1162561190 Owner's Manual page 15

5o Carefully
Insert and
twlst screw-
driver at
each brush
support to
free brush
frombase
TO REPLACEBELT:
1. Slide washers and brush supports onto brush
assembly
2. Install new belt
over motor drive,
then over brush
sprocket.
NOTE: See PARTS
AND FEATURES
for Belt #.
mm
Im
3, Snap brush
supports into place
on base. Be sure
brush suppods are not
upside-down
6oRemove worn
belt.
7oSlide brush sup °
ports off to check
and clean brush
support areas.
See BRUSH
ASSEMBLYfor pic-
ture of complete
b_t_sh assembly.
4. Une up front of
cover and base
Rest cover on front
edge of bose as
shown.
i....... ,......, ,,,,,,,, ,,,,
Baee
5. Til! cover to
back, Press cover
firmly until side tabs
snap into place
ReplQce cover
screws,Ilght bulb
and tght cover
15