Kenmore 69142 Use & Care Manual page 5

I @*--D
*--C
@_-- D
A 5 tt
/18 hex nut screws I Phillips screws
B Tophinge J Bottom hinge pin
C Hinge shim(s) K Bottom hinge
D Round shim(s) L Bottom hinge
E 5/18" h ex nut shim(s)
F Centerhingepin M 3/8"screws
G Centerhinge
H Centerhinge shim(s)
10. Reverse door stops.
• Locate door stop at bottom edge of refrigerator door.
Unscrew two Phillips screws to remove door stop,
Remove the two Phillips screws on opposite edge
of door, Mount door stop on opposite side, Replace
remaining screws in empty mounting holes,
• Repeat the above instructions to reverse door stop
on freezer door,
A Door B Doorstop
11. Reverse doors by performing the following steps:
• Remove plugs and screws in opposite side of
refrigerator cabinet. Insert in holes left from hinge
removal.
12. Mount bottom, center, and top hinges with shims on
opposite side of cabinet.
• Replace bottom hinge on opposite side of cabinet.
Verify hinge shims are in position before screwing
into place. After placing hinge pin into outside hole,
replace round shims. Some bottom hinges may
have plugs in holes. In case of this, remove plug
from outside hole, put pin in hole, and replace plug
in empty hole.
• Replace top hinge and shims, but allow enough
clearance to slide hinge side of refrigerator door into
place. Tighten down top hinge to securely hold door.
W "(18 mm)
Use a dime at top to space door -16,--
from cabinet.
Handle side of door should be approximately
1/,, (3 mm) higher than hinge side. Door will
-8
become level when it is loaded with food.
11/16"
(18 mm)
1/8"
(3 mm)"
13. Mount refrigerator handle on opposite side of door
using mounting screws removed in previous step.
• Snap handle trim into place and replace screw.
14. Mount freezer handle to opposite side of door using
mounting screws removed in previous step.
• Angle front edge of handle cap downward toward
back lip of freezer handle. Verify bottom tab on
freezer cap slides under rear lip of freezer handle.
Snap rear edge of handle cap in place.
15. Check unit for proper leveling following instructions in
section titled Leveling Refrigerator, starting with step
3.
16. Replace toe grille and bottom hinge cover.
Important: Look for arrow printed on inside of grille to
insure proper placement.
• Snap top portion into place first. Press down on
lower part of grille until bottom portion snaps into
place.
!
€'1
I!1