Download  Print this page

Door Removal - Kenmore 25369232700 Use & Care Manual

Top mount
Hide thumbs

Advertisement

Door Removal instructions
H_nge
Screw
_Top
Hinge
Cover
Q
Top Hinge
Cable
_ff""/_
Block
Bottom
Hinge
Center
Hinge
Tools Necessary:
_nc]
-lat Head
Screw
Driver
Sockel
Wrench Sel
3/8"
Fixed
w[encP
DOOR
REMOVAL
iNSTRUCTIONS:
If your refrigerator will not fit through an entrance area. you can reduce its size by
removing the doors. Check first by measuring the entrance.
IMPORTANT: Before you begin, turn the refrigerator temperature control to "0" and
remove the electrical power cord from the wall outlet. Remove food from door shelves.
1.
Disconnect electrical supply.
2.
Remove toe grille (see figure on page 5).
To remove freezer door:
1.
Remove top hinge cover and screws.
2.
Trace around the hinge with a soft lead pencil. This makes reinstallation easier
3.
Remove top hinge and lift door off bottom hinge pin.
4.
Reinstall door in opposite order and mannerof removal.
To remove refrigerator
door:
1.
Place wood block under door to support itsweight.
2.
Unfasten the multi-wire cable bracket by removing its screw from the cabinet.
3.
Detach the multi-wire cable connector located below the door.
Place your thumbs on flat sides of each connector grasp firmly, and bend both
ends back and forth while pulling apart.
NOTE:You may need to insert a flat screwd fiver between the connector ends to
release the locking tab (see illustration)
4.
Detach the water tube from the connector located below the door. The connector
releases when you press its outer sleeve inward.
NOTE: If refrigerator has been used. have a container ready to catch excess water
from tube.
5.
Remove the bottom hinge screws and hinge, holding the door as its weight rests
on the wood block. Lay the door on its side to avoid damage to cable and tube.
6.
Remove the center hinge screws and hinge. Ensure plastic washer stays on
hinge pin
7.
Reinstall door in opposite order and manner of removal. When both doors are
reinstalled, connect water line by inserting tube and pushing until mark touches
face of fitting. Connect cable, replace toe grille, and plug in electrical power cord.
\
Connector
_)usn until mark touches face of fitting

Advertisement

loading

This manual is also suitable for:

253692337002536923470025369239700253970