Kenmore K90-150 Owner's Manual page 21

replace any part of the control system and any
gas control which has been under water.
Safe lighting and other performance criteria were
met with the gas manifold and control assembly
provided on the boiler when the boiler underwent
tests specified in ANSI Z21.13-latest revision.
1. STOPI Read the safety information above be-
fore operating this appliance.
2. Set the thermostat to the lowest setting.
3. Turn off all electrical power to the appliance.
4. This appliance does not have a pilot. It is
equipped with an ignition device which automat-
ically lights the burner, Do NOT try to light this
burner by hand.
5. Remove the front jacket panel.
6. Turn off the gas shut off valve. Valve handle
should be perpendicular to the gas pipe.
7. Wait five minutes for any gas to clear. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow instructions under "What To
Do If You Smell Gas" (previous page). If you do
not smell gas, go to the next step.
8. Turn the gas shut off valve to the "On" posi-
tion. The handle on the valve should be parallel
to the gas pipe.
9. Replace the front jacket panel.
10. Turn on all electrical power to the appliance.
11, Set thermostat to desired setting.
12, If the appliance will not operate, follow the
instructions in "To Turn Off Gas To Appliance"
(below) and call your service technician or gas
supplier.
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
3. Remove the front jacket panel.
4. Turn gas shut off valve off. Handle should be
perpendicular to the gas pipe.
5. Replace the front jacket panel.