Pile Height Selection; Suggested Pile Height Settings - Kenmore 116.31100 Use & Care Manual

i
PILE HEIGHT SELECTION AND SETTING t
i
To select a pile height setting:
Turn off vacuum cleaner. Select a pile
height setting by tilting the cleaner back
until the front wheels are lifted slightly
off the floor.
Slide the adjustment lever to the correct
setting.
There are four (4) pile height settings on
the vacuum cleaner. Use the LOW setting
for most low-pile carpets and bare floor
cleaning (with agitator OFF), and the
HIGH setting for high-pile carpets like
shag carpet, scarier rugs, etc. Use the
other settings as needed for carpet
heights in between.
Pile Height
_k CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator is turning.
Damage to carpet may occur.
I CHECK BAG INDICATOR
When the vacuum cleaner is running with
normal air flow, the light on the CHECK
BAG indicator is off. The light comes on
whenever the airflow becomes blocked. If
that occurs, check the disposable dust bag,
motor safety filter and other possible clog
locations shown in CLOG REMOVAL.
NOTE: It is normal for the CHECK BAG
indicator to come on when using certain
attachments, due to reduced airflow
through attachment. No maintenance is
required.