Height Selection And Setting; To Select A Pile Height Setting; Suggested Pile Height Settings; Carpet Setting - Kenmore 116.34725 Owner's Manual

To select a pile height setting:
Turn off cleaner. Select a ptle height setting
by tdtmg the cleaner back unt=l front wheels
are lifted slightly off the floor as illustrated
Slide the adjustment lever to the correct
setting.
SUGGESTED PILE HEIGHT SE'I-I'INGS
You may need to raise the height to make
some jobs easier, such as scatter rugs and
longer pile carpets. Suggested settings are:
HIGH: shag carpet, long pile, plush, scatter
rugs.
MED: medium to long pile.
LOW: short to medium pile
EX LOW: very low p_le
WARNING
Personal Injury Hazard
DO NOT place hands or feet under-
neath the unit when changingfrom
the bare floorto the carpet pile
height setting. The agitator beginsto
revolve rapidly when the vacuum is
turned on and is in the carpet set-
Ung.
Bare floor setting: Slide the carpet/bare floor
selector all the way back and down toward
the bottom of the nozzle unt=l it locks into
place.
In th_s pos_hon the brush assembly does not
revolve. This setting should be used for
cleaning hardwood and hie floors and when
any attachments (tools) are used
Carpet setting: Slide the selector all the way
forward and up to the carpet
position.
In this position the brush assembly will turn.
When carpets are being cleaned the selec-
tor should be in this position.
Attention: Refer to your carpet manufactur-
ers cleaning recommendations. Some more
delicate carpets may require that they be
vacuumed with the agitator turned off, to
prevent carpet damage.
!
r. . CAUTION
Do not allow vacuum cleaner to remain
in one spot for any length of time when
the agitator is tuming. Damage to car-
pet may occur.
Note: For longer belt life, turn vacuum off
before moving selector. Failure to do so can
cause the belt to rub on the selector shaft
and may result in the belt becoming hot and
creating a burning rubber smell.
Carpe_are
Floor Selector
To Bare Floor
Position
To Carpet
Position
7