Do not overtlghten
Overtighteningcould strip the screw
Do not operate the cleaner without the
screw in place
Make sure the quick release upper cord
hook is in the upright position.
wire tie from the power cord.
Lock the cord into
place by forcing it
into the locking
notch on the body of
the quick release
upper cord hook as
shown. This helps
keep the power cord
out from under the
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
HOW TO START
Turn the quick
cord hook to
and down to
Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook.
Note: To reduce the risk of electric shock,
this vacuum cleaner has a polarized
one blade is wider than the other.
This plug will fit in a polarized
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician
to install the
proper outlet. Do not change the plug in any
Plug the polarized
power cord into a 120
Volt outlet located near the floor.
Personal Injury and ProductDamage
• DO NOT plug In if switchIs In the ON
position Personal Injuryor damage
• DO NOT use outlets above counters
Damage from cord to itemsIn surround-
ing area could occur