Options Selection Pad; Tones - Kenmore 880.54202 Use & Care Manual

Style I Electronic Oven Control
When power is first supplied to the appliance, "12:00 PM" will
appear on the display. See CLOCK section to set time of day.
If "12:00 PM" appears at any other time, a power failure has
occurred. Press CANCEL and reset the clock if needed.
Style 2 Electronic Oven Control
When the oven is in use, the display shows the oven temperature
and heat source(s). During Timed Cooking, this display also
shows a vertical bar and minute time countdown and the stop
time (if entered).
If "Err" appears on the display, an invalid pad was pressed. Press
CANCEL and retry your entry. When the oven is not in use, only
the time of day is shown on the display.
Styles 3 & 4 Electronic Oven Controls
When power is first supplied to the appliance, "PF" will appear on
the display. Press CANCEL to clear "PF" from the display.
If "PF" appears at any other time, a power failure has occurred.
Press CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
Style I Electronic Oven Control
The START pad begins any oven function. The display will show
"SET TEMP OR TIME OR PUSH START."
Style 2 Electronic Oven Control
The START pad begins any oven function except the Timer and
Control Lock. If not pressed within 5 seconds after pressing a
pad, "START?" will appear on the oven display as a reminder. If
not pressed within 4 minutes after pressing a pad, the oven
display will return to an inactive mode (blank) and the
programmed function will be canceled.
Styles 3 & 4 Electronic Oven Controls
The START pad begins any oven function. If not pressed within
5 seconds after pressing a function pad, the "START?" or "?"
indicator light will appear on the display (on some models).
If not pressed within 5 minutes after pressing a function pad,
the oven display will return to the time of day mode and the
programmed function will be canceled.
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer, Control Lock or Warm Drawer (on some models).
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and TIMER are off.
1. Press CLOCK (on some models). "SET CLOCK TIME" will
appear on the display.
2. Depending on your model, press the HR or MIN or TIME/
TEMP "up" or "down" arrow pads to set the time of day,
including a.m. or p.m.
3. Press CLOCK or START.
Style 2 Electronic Oven Control
The OPTIONS selection pad allows you to access 7 hidden
functions within the Electronic Oven Control. These hidden
functions allow you to change the oven temperature between
Fahrenheit and Celsius, turn the audible signals and prompts on
and off, and adjust the oven calibration.
To Use: Press OPTIONS (on some models). The oven display will
scroll through the various options, starting at 1 and ending in 0.
You can also press the OPTIONS selection pad and number pad
to quickly access the desired hidden function.
OPTIONS HIDDEN FUNCTIONS
1 °F on
2 °C on
3 Tones on
4 Tones off
7 Event tones on
8 Event tones off
9 See "Oven Temperature Control" section
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheating (long tone)
• Function has been entered
• Reminder (on some models), repeating each minute after the
end-of-cycle tones
Three tones
• Invalid pad press
Four tones
• End of cycle
12