Kenmore 116.31079 Owner's Manual page 14

TO REPLACE BELT:
Drive
Shaft
Loop the new belt on the motor drive shaft,
NOTE: See PARTS AND FEATURES for
Belt #o
Loop the other end of the belt on the belt
groove on the brush assembly..
Agitator
Base Slot
Slot
Align the square extension on each end cap
with the slots in the frame of the base_
Press firmly, checking to see that each end
is completely inserted.
Motor
Drive
Shaft
Agitator
Check to see that the belt is centered in the
belt groove and that the brush assembly
turns freely,
Reinstall the lower plate by placing the front
tabs on the plate into the slots on the nozzle
housing and pushing the plate to the rear
until the back clips snap into place_ Pull the
tabs to the outside°
\
Return the cleaner to the upright position
before plugging into the electrical outlet.
14