Download  Print this page

Surface Units And Drip Pans; Lift-Up Cooktop - Kenmore 363.42482 Use & Care Manual And Installation Instructions

Electric cooktop
Hide thumbs

Advertisement

SURFACE
UNITS AND DRIP PANS
To clean the surface units, turn the control to the highest
setting for a minute. The coils will burn off any soil.
CAUTION:
'
:
'
• Be sure all the controls
are turned
to OFF and
the surface
units are cool before
attempting
to
remove them.
. .......
-Do
not immerse
the surface
units in liquids
of any kind.
• Do not clean the surface
units in a dishwashe
r.
• Do not bend the surface
unit plug terminals.
° Do not attempt to clean, adjust or in any way
repair the plug-in receptacle:
TO REMOVE
A SURFACE
UNIT
To remove the drip pans for
cleaning, the surface units
must be removed first.
Lift the surface unit about 1
inch (2.5 cm) above the drip
pan and pull it out.
Do not lift the surface unit more than 1 inch
(2.5 cm). if you do, it may not lie flat on the drip pan
when you plug it back in.
Repeated
lifting of the surface unit more
than 1 inch (2.5 cm) above the drip pan can
,,permanently damage the receptacle.
TO REPLACE
A SURFACEUNIT
• Replace the drip pan into the recess in the
cooktop.
Make sure opening in the pan lines
up with the receptacle.
• Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle.
• Guide the surface unit into place so that it rests evenly.
DRIP PANS
Remove the surface units. Then
lift out the drip pans.
Clean the drip pans by hand with
warm, soapy water.
To remove burned-on foods,
soak them in hot, soapy water
Drip pan
for several hours. Then scrub with a soap filled plastic
scouring pad if necessary.
Rinse with clean water and polish with a clean soft cloth.
The drip pans may also be cleaned in the dishwasher.
Clean the area under the drip pans often. Built-up soil,
especially grease, may catch on fire.
10
Do not cover drip pans with foil. Using foil so close.
,i:::i
to the receptacle could cause shock, fire or damage
to the cooktop.
_:_:
LIFT-UP COOKTOP
Clean the area under the
cooktop often, BuUt-up soil,
especially grease, may
catch on fire.
To make cleaning easier, the
entire cooktop may be lifted.
Support/rod
t--_----_
--
Be sure all surface units are
UrP°_°rt "d-
.,_
turned off and are cool before
s
,--T--p_lff--3
(
raising the cooktop.
1. Remove all four control
knobs. See the Control
Knobs section.
Be sure to secure the cooktop
2. Remove one of the front
support
rod in the
cooktop
Strike catch:
surface units and drip pans
and use this opening to grasp the cooktop. See the
Surface Units and Drip Pans sections.
3. Lift the cooktop.
4. Raise the support rod into place and hook it into the
bracket on the underside of the cooktop to hold it in
place while cleaning.
TO CLEAN THE COOKTOP:
Use hot, soapy water and a clean cloth to clean the
surface under the cooktop. To remove burned-on spills,
use a cleansing powder. Rinse well, then polish with a
dry cloth.
TO LOWER THE COOKTOP:
1. While holding the cooktop up with one hand, carefully
disengage the support rod from the bracket and return
it to its original location.
,
3.
.
Gently lower the cooktop.
To fasten the cooktop down, press on the front of the
cooktop to make sure the strike engages the catch.
Replace any drip pans and surface units that you
removed.
5. Replace the control knobs.

Advertisement

loading

This manual is also suitable for:

363.42484363.42489363.43482363.43489363.43484