Download  Print this page

First Steps - Kenmore 253.78296895 Owner's Manual

Hide thumbs

Advertisement

First Steps
ROLLER ADJUSTING
BOLT
Adjusting Front Rollers
Replacing Toe Grill
Before
starting
the refrigerator,
follow
these important
first
steps:
Location
Choose a place that is near a grounded electrical outlet
o
i
o
DO NOT use an
extension cord or an adapter plug
If possible, place the refrigerator out of direct sunlight and away from the range,
dishwasher or other heat sources
The refrigerator must be installed on a floor that is level and strong enough
to support a fully loaded refrigerator,
Consider water supply availability for models equipped with an automatic ice
maker,
Installation
°
tf you need to remove the handles to move the refrigerator through narrow
doorways, see "Removing Handles and Doors" in this Owner's Guide,
-
Do not install the refrigerator where the temperature wilt drop below 60°F
(I 5°C) or rise above t 10°F(43°C) The compressor will not be able to maintain
proper temperatures
In a recessed installation, allow an extra 1/2 inch (10-15 ram) on each side for
ease of installation
°
If the hinge side of the unit will be placed against a wall, allow a 1-3/4 inch
(44 ram) space between the wail and the refrigerator
Door Opening
The doors should open to allow easy access to a counter when removing food
°
Do not position the refrigerator so you have to walk around the refrigerator
doors
Leveling
Al! four corners of the refrigerator must rest firmly on a solid floor,
1, Open refrigerator door and remove toe grill
2, Use a 3/8"socket wrench or nutdriver to adjust rollers as shown,
RAISE THE FRONT of cabinet enough so doors will close freely when opened
halfway
3 Level cabinet side to side
4 To replace toe grill, line up clips with holes, and push grill straight on,
Cleaning
°
Wash the inside, all removable parts and the outside with mild detergent and
warm water Wipe dry DO NOT USEHARSH CLEANERSON THESESURFACES.
o
Do not use razor blades or other sharp instruments, which can scratch the
appliance surface, when removing adhesive labels. Any glue left from the
tape or energy label can be removed with a mixture of warm water and mild
detergent, or touch the glue with the sticky side of tape already removed
°
DO NOT REMOVE THE SERIALPLATE

Advertisement

loading

This manual is also suitable for:

253.78299890