Table of Contents
Advertisement
Effortless
TM
Oven
Rack system
(some models)
Some models are equipped with a special oven rack system
that automatically
partially extends the oven rack from the
interior oven glides to assist in easier access to your food
items. This feature works whenever the oven door is
opened or closed.
To assemble the Effortless "MOven Rack system:
1.
Locate all required parts. You will need the supplied
oven rack (Effortless
TM
Oven Rack is a flat rack with a
special dark coating on the left and right rack
sides) and the 2 supplied chrome connector arms.
2.
Open the oven door. Be sure the oven iscompletely
cool before proceeding.
3.
Place the oven rack in positions 2, 3 or 4 only (see
previous page to verify positions).Be sure the rack
connector brackets are at the rear of the range and
pointing towards oven bottom (See Fig. 2).
4.
Assemble one connector arm at a time. With the oven
door open and the oven rack in place, install one end of
the connector arm to the hole in the door connector
bracket (Fig. 1) and the other end in the hole in the
rack connector
bracket (Fig. 2 and as in Fig. 3). The
oven rack may need to be adjusted in or out in the rack
position to match the length of the connector arm.
5.
While holding the connector arm in place, twist the
connector arm so the ends of the connector arm point
upwards (See Figs. 4 & 5). The connector arm should
now be locked into position.
6.
Repeat steps 4 and 5 for the other connector arm.
7.
Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out of
the oven freely when the door is opened or closed.
Only the Effortless "MOven Rack system should
be used in oven rack position 2. Placing ANY other
rack in oven rack position 2 will prevent the oven
door from fully closing and may damage the oven
door, oven cavity or the door connector brackets.
• If the rack system is not assembled with the connector
arms the Effortless
TM
Oven rack may be used in oven
rack positions 2 thru 6. Do not attempt to use the
Effortless T" Oven rack in rack position 1.
door
connector
bracket
_"--_::_
rack connector
..........
_
bracket
arm
Never pick up hot oven rack parts. Make sure the
oven and oven racks are COMPLETLY cool and safe to
touch before attempting to assemble or disassemble the
EffortlessT" Oven Rack.
Remove ALL oven racks and accessories
before
starting a self-clean
cycle. If the oven racks are left in
the oven during self-clean, the glide ability of the
Effortless
TM
Oven Rack system will be damaged and will
cause oven racks to loose their shiny finish. Remove ALL
i
oven racks and clean according to instructions provided in
the Care & Cleaning section of this manual.
left and right
door connector
brackets
with connector arm ends
shown in locked
position
(pointing
upwards)
Fig. 6 - Effortless
TM
Oven Rack after assembly
connector
arm
Advertisement
Table of Contents
