Effortless Tm Oven Rack System And Assembly - Frigidaire FGGF3032MFA Use & Care Manual

Effortless
TM
Oven Rack system
Some models are equipped with a special oven rack
system that automatically partially extends the oven rack
from the interior oven glides to assist in easier access to
your food items. This feature works whenever the oven
door is opened or closed.
To assemble the Effortless "MOven Rack system:
1. Locate all required parts. You will need the supplied
oven rack (Effortless T" Oven Rack is a flat rack with a
special dark coating on the left and right rack
sides) and the 2 supplied chrome connector arms.
2. Open the oven door. Be sure the oven is completely
cool before proceeding.
3. Place the oven rack in positions 2, 3 or 4 only (see
previous page to verify positions).Be sure the rack
connector brackets are at the rear of the range and
pointing towards oven bottom (See Fig. 2).
4. Assemble one connector arm at a time. With the oven
door open and the oven rack in place, install one end
of the connector arm to the hole in the door
connector bracket (Fig. 1) and the other end in the
hole in the rack connector bracket (Fig. 2 and as in
Fig. 3). The oven rack may need to be adjusted in or
out in the rack position to match the length of the
connector arm.
5. While holding the connector arm in place, twist the
connector arm so the ends of the connector arm point
upwards (See Figs. 4 & 5). The connector arm
should now be locked into position.
6. Repeat steps 4 and 5 for the other connector arm.
7. Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out
of the oven freely when the door is opened or closed.
• Only the Effortless "MOven Rack system should
be used in oven rack position 2. Placing ANY other
rack in oven rack position 2 will prevent the oven
door from fully closing and may damage the oven
door, oven cavity or the door connector brackets.
• If the rack system is not assembled with the
connector arms the Effortless T" Oven rack may be
used in oven rack positions 2 thru 6. Do not attempt
to use the Effortless T" Oven rack in rack position 1.
door _"_::::::_ rack connector
connector .......... bracket
bracket
Fig. 3 - assembly
of the Effortless T"
Oven Rack
open oven
door
connector
arm
Never pick up hot oven rack parts. Make sure the
oven and oven racks are COMPLETLY cool and safe to
touch before attempting to assemble or disassemble
............ the Effo lessT:OvenRack: ....................................................................................................................................................
Remove ALL oven racks and accessories before
starting a self-clean cycle. If the oven racks are left
in the oven during self-clean, the glide ability of the
Effortless T_ Oven Rack system will be damaged and will
cause oven racks to loose their shiny finish. Remove
ALL oven racks and clean according to instructions
provided in the Care & Cleaning section of this manual.
right
door connector
brackets
with connector arm ends
shown in locked position
(pointing upwards)
Fig. 6 - Effortless TMOven Rack after assembly
connector
arm
9