Setting Minute Timer; Setting Lockout Feature - Frigidaire CGEF304DKF2 Use & Care Manual

SETTING MINUTE TIMER
The TIMER ON'OFF padcontrols theMinuteTimerfeature,
The Minute Timer serves as an extra timer in the kitchen
that will beep when the set time has run out, It does not
start or stop cooking, The Minute Timer feature can be
used during any of the other oven control functions, Refer
to "Minimum and Maximum Contro! Pad Settings" for time
amount settings,
To set the Minute Timer (example for 5 minutes)
i. Press TIMER ON.OFF. " .... " will appear in the
display.
2. Use the number pads to set the desired time in the
display; press S.
3. Press START. The time will begin to count down with
"5:00" in the display.
Note: If START is not pressed the timer will return to the
time of day after 25 seconds.
4. When the set time has run out, "End" will show in
the display. The clock will sound with 3 beeps every 5
seconds until TIMER ON.OFF is pressed.
To cancel the Minute Timer before the set time has
run out
1. Press TIMER ON.OFF. The display will return to the time
of day.
SETTING + 1 MIN FEATURE
The + 1 MIN pad is used to set the Add 1 Minute feature.
When the + 1 MIN pad is pressed, 1 minute is added to
the Minute Timer feature if this feature is already active.
If the Minute Timer feature is not active and the + 1 MIN
pad is pressed, the Minute Timer feature will become active
and will begin counting down from 1 minute.
SETTING LOCKOUT FEATURE
The _ pad controls the Lockout feature. The Lockout
feature automatically locks the oven doors, the control
panel and the cooktop. It does not disable the Minute
Timer or the interior oven lights.
To activate the Lockout feature
1. Press and hold _ for 3 seconds.
2. After 3 seconds "Loc" and "Control" will appear, a
beep will sound, "UPPER", "LOWER" and "DOOR" will
flash in the display. Once the oven door is locked the
"DOOR" will stop flashing and remain on along with
the "Loc', "Control" and the 191 icon will appear.
To reactivate normal operation:
1. Press and hold _ for 3 seconds. A beep will sound.
The "UPPER', "LOWER" and "DOOR" will flash in the
display until the oven door has completely unlocked and
the I_1icon will disappear.
2. The unit is again fully operational.
The surface elements cannot be activated when the
Lockout feature is active (see the section: The electronic
surface element control (ESEC)),