Showing The Clock (Display); Con'ecting The Clock - JVC FS-X3 Instructions Manual

Using the Timers
3 Press the SET button.
The minute digits of the time indication blink on the dis-
play.
• To return to the hour setting, press the CANCEL
button.
4 Press the I_ or < button to set the minute.
5 Press the SET button.
"ADJUST OK!" appears on the display. The Clock in-
dicator (a(a_) remains lit, Then, the selecled time is set
and the seconds start counting from 0.
Example:
P_f-=Ti I I =-=LI'-:
L.'l-li' ,, ,,,,,
1... i ._.i i ,
I Alternates
DRILY OFF?
CAUTION:
• if there is a power failure, the clock loses its
setting. "0:00" and the Clock indicator (J_)
blinks on the display and the clock must be
reset.
Showing the Clock (DISPLAY)
OH
,,,J
"_4 L.,4; ,_.,--,
-- -
,,- i,,.m
_.' J( _,
/t kI (clock)
Display the source
(dock is cinceled )
You can show the era-rent time on the display.
TO display the clock, press the DISPLAY button on the
Remote Control.
To return to the normal display, press 1he same button
I \111
€15 20
/II\
2 Perform steps 2 to 5 in "Setting the Clo-
ck" on page 22-23.
again.
•-- [] ..-- =.-..
•" . h" -= =--"I
= m =meN mime
Correcting the Clock
Use the following method to correct any clock shift.
• When the System is in powersaving mode, nothing ap-
pears on the display. To see the clock, press the DIMMER
button on the Remote Control
• The clock may gain or lose one to two minutes par month.
• Ifthereisapowerfailure, theclocklosesitssetting, "0:00"
blinks on the display and the clock must be reset To reset
the clock, see "Setting the Clock" on page 22-23
You can correct the clock whether the System is turned
on or off.
1 Repeatedly press the CLOCK/TIMER bu-
tton to show the clock on the display.
Each time you press the button, the display changes as
follows.
Setting the Daily Timer
Once you have set the Daily Timer, the timer will be acti-
vated at the same time every day.
The "DAILY" indicalor on the display shows that the Daily
Timer you have set is in effect.
You can set the Daily Timer whether the Syslem is on or off
(but not in power saving mode (See page 11)).
• If you have made a mistake while setting the timer, press
the CANCEL button on the Remote Control. However, this
does not always cancel the current setting. If the CANCEL
button does not work, press the CLOCK/TIMER button on
the Remote Control repeatedly until the display returns to
the original display, and start from the first step.
23