Frigidaire FAH08ES1TA11 Use & Care Manual page 7

Air Conditioner Features
(continued)
TO OPERATE ON FAN ONLY:
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
Note: Use this function only when cooling is not desired, such as for room air
circulation. You can choose any fan speed you prefer EXCEPTAUTO FAN.
UGHTON
During this function, the disptaywitl show the actual current temperature, not the set temperature as in the cooling mode.
Fan Only cannot be selected when the unit is in the 'Remote Sensing' Mode. (On those units with that feature).
TO USETHE
ENERGYSAVERFEATURE:
LmGHTON
YOU WILL SEE:
DO THIS: ......
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
Note: ln this mode the fanwil_continuetorunfor3minutesafterthecompressorshutsoff`ThefanthencycIesonfor2
minutes atl0minuteintervatsunfiltheroomtemperatureisabovethesettemperature at which time the unit cooling
system starts again.
TIMER-DELAY
START/STOP FEATURE:
FIRST
DO THIS:
PRESSTIMER
BUTTON
THg
DO TH ] S :
PRESS TEMP/TIMER
BUTTON
YOU WILL SEE
THE TIME CHOSEN:
LmGHT ON
Note 1: For Delay Stop the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow (A) or DOWN arrow (v) to change the delay time by .5 hour increments up to
10 hours, then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8 7.5 7
etc.). The Delay Start mode automatically setects cooling with maximum Fan Speed. The temperature maintained will be the
same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature
is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining
until the unit witl start/stop. Turning the unit "ON" or "OFF" at any timer wilt cancel the Delay Start/Stop function. The delay
Start/Stop feature wilt work until the unit either starts or stops. Once this has happened then the above steps have to be
repeated again.