Frigidaire FEB30S5DSG Use & Care Manual page 29

Electronic Control Settings
USERPREFERENCES
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The User Preferences menu includes all user defined options. This feature enables you to
control the various options of the electronic controls. This menu features the Time of Day,
Celsius or Fahrenheit display mode, Continuous Bake or 12 Hour Energy Saving modes,
Clock display or No-Clock display, 12 Hours Time of Day or 24 Hours Time of Day, Audio
Control, and Adjusting the oven temperature. The User Preferences menu is only available
when the oven is not being used (not cooking).
To browse through the User Preferences menu:
1. Press USER PREF _ to bring up the User Preferences menu.
2. Press USER PREF _ again to browse through the menu pages.
4-
3. Press hi or Io to toggle between the available options.
4. Press START 4_ while the chosen option is on display to change.
5. Press CANCEL @ when finished to get back to the standard oven display.
User Preferences menu items:
• CLO 12:00; Setting the clock. • F-C F ; Fahrenheit / Celcius display.
• CLO on; Clock on!off. • AUd ;Audio on/offand volume.
• CLO 12hr; 12/24 hour time of day display. • E S on ; 12 hour Energy Saving on/off.
• UPO; Adjusting oven temperature. • rSt ; Reset to default factory settings.
SE (NG THE CLOCK- T)MEOF DAY:
The clock may be set for 12 or 24 hour time of day operation (see advanced settings section).
The clock has been preset at the factory for the 12 hour operation. When the range is first
plugged in, or when the power supply to the range has been interrupted, the display will show
"CLO 12:00". The clock must be set before the oven can be used.
When power to the unit has been interrupted, "12:00" appears and flashes in the display. To
set the Clock in this case, skip step 1 in the example below and follow steps 2 and 3.
To set the clock (example for 1:30):
1. Press USER PREF _f.gJ until you get to the CLO 12:00 menu page.
2. _ress: 19,\=t/, U/pads to set the time ofdayto 1:30. The pads hi or io can also be pressed
to raise or lower the actual time displayed.
3. Press START <_> to accept the changes and go back to user preferences menu display.