ICP 84 Series Operating And Maintenance Instructions Manual

CONTENTS
Page
PRODUCT INFORMATION ........................... 1
INTRODUCTION ................................... 1
SAFETY CONSIDERATIONS ......................... 1
UNIT INSPECTION ................................ 1 3
I. Front Panel ................................. 2
ELECTRICAL DATA ............................... 3,4
I. All Units ................................... 3
II. Voltage Supply .............................. 4
INSTALLATION ................................... 4-6
I. Chassis Installation .......................... 4
II. Wall Thermostat Installation ................... 6
OPERATION ..................................... 7,8
I. Comfort Controls ............................ 7
II. Operating Controls .......................... 7
III. Operating Modes ............................ 8
CARE AND MAINTENANCE ........................ 8,9
I. Indoor-Air Inlet Filters ........................ 8
II. External Parts ............................... 8
III. Internal Parts ............................... 9
PREVENTATIVE MAINTENANCE ..................... 9
TROUBLESHOOTING .............................. 10
ACCESSORIES ................................... 11
WARRANTY ..................................... 12
FOR SERVICE CALL TOLL-FREE
1-877-875-3362
IMPORTANT: Read entire installation instructions before
installing unit.
PRODUCT INFORMATION
If you have problems or questions concerning your Air" Con-
ditioner or Heat Pump unit, you will need the following
information. Model and serial numbers are on tire nameplate
of the cabinet.
Model No.
Serial No.
Date of Purchase
Dealer's Address
Dealer's Phone Number
Cancels: OM 84 07 1 OM 84 07 2
4/15/03
INTRODUCTION
The 84 series of packaged terminal air conditioning units
(PTAC) offers 3 units: 842 cooling unit, 840 cooling unit with
electric heat and 841 heat pump unit with electric heat.
Units are available in 4 different capacity sizes: 7000, 9000,
12,000, and 15,000 Btuh. Units are available in 208/230 and
265 voltages.
SAFETY CONSIDERATIONS
The 84 series PTAC traits meet strict safety and operating
standards. It is important to install or service the system so
it operates safely and efficiently For safe installation and
trouble-free operation, carefully read the Installation
Instructions before beginning. Follow each installation step
exactly as shown. Observe all local, state, and national dec-
trical codes. Pay close attention to all warning and caution
notices given in this manual.
The Warning symbol refers to a hazard or unsafe practice
which can result in severe personal injury or death. The
Caution symbol refers to a hazard or unsafe practice which
can result in personal injury or product or property damage.
The information in these instructions is applicable for most
installation sites and maintenance conditions. It is recom
mended that this unit be installed properly by qualified
installation technicians in accordance with the Installation
Instructions provided with the unit,
IMPORTANT: Before installation, check that the voltage of
the electric supply is the same as the voltage shown on the
nameplate.
UNIT INSPECTION
Examine unit for" damage incurred during shipment. File a
claim immediately with the transit company if damage is
found.
The data information plate (Fig. 1), located on fi'ont of unit
under front panel, lists the model numbeL voltage ranges,
and other" important electrical information about this prod
uct. Reading and understanding this material is important
for proper use of this unit. To access the information plate,
the front panel must be removed; see Fig. 2.