Troubleshooting - Hoover Concept One Manual

END SECTION
WASH E R
BEARING
LOCATOR
4. Reassemble agitator parts.
Line up Iocator on end sections
with slot on agitator. Note: Large
Iocator on pulley end must align
with large notch on agitator.
Screw on end plates and tighten.
5. Should you accidentally dis-
place the bearing during disas-
sembly, reassemble as shown.
Replace belt, agitator and bottom
plate.
If you have a problem
This appliance was inspected thoroughly and was in good operating con-
dition when it was shipped from the factory. If a minor problem develops,
it usually can be remedied quite easily when the cause is identified. Ac-
cordingly, this check list is provided for your convenience.
Problem Possible cause
Cleaner 1. Not firmly plugged in,
won't 2. No voltage in wall plug.
run 3. Blown fuse/tripped
breaker.
Possible solution
1. Plug unit in firmly,
2. Check fuse or breaker.
3. Replace fuse/reset breakeu
won't belt.
pick up 2. Agitator brushes worn.
3, Bag full.
4. Obstruction in cleaner.
5. Bag not opening.
2. Replace brushes.
3. Change throw away bag.
4. Clear pivoting dirt duct
and/or dirt tube.
5. Check for firm bag con-
nection.
If the problem persists, check the Yellow Pages of your telephone book
under "Vacuum Cleaners - Household" for your nearest Hoover Factory
Service Center or Authorized Warranty Service Dealer where approve(
HOOVER service and genuine HOOVER replacement parts may be ob-
tained. The warranty provided with this product has a listing of the
Hoover Factory Service Centers. If you are unable to obtain the informa-
tion you need from the Yellow Pages, contact a Hoover Factory Service
Center to find your nearest Authorized Warranty Service Dealer. For
service under warranty, follow the instructions in the Warranty provided
with this product.
Do not send your cleaner to The Hoover Company in North Canton for
service as this will only result in delay.
21