Using The Remote To Control Audio Equipment - Hitachi 61HDX98B User Manual

USING THE REMOTE
USING THE REMOTE TO CONTROL AUDIO
EQUIPMENT FUNCTIONS
Operating the precoded function for your audio equipment.
This remote is designed to operate certain types of audio equipment. You must first
program the remote to match the remote system of your audio equipment.
1. Set the MULTI-PAGE switch, on the side of the remote control, to AUDIO.
2. Turn ON the component (AMP, CD or TAPE) you wish to control with the
remote.
3. Press and release AMP, CD or TAPE button to switch to AMP, CD or TAPE
mode.
4. Aim the remote at the front of the component.
5. Press and hold down the AMP, CD or TAPE button.
6,
While holding down the button, enter the 2 digit preset code which matches
the component as shown on page 28. The remote will turn OFF the component
when the correct code is entered, indicating that the remote is now
programmed.
7. Repeat steps 2-6 until all audio equipment preset codes are programmed into
the remote.
A]q-ENTION: If the component does not turn OFF after 5 seconds, the wrong I
code was entered. Consult page 28 again and try one of the other I
codes listed for that component brand name. I
NOTES:
• If your audio equipment cannot b e operated after performing the above
procedures, your audio component code has not been precoded into the
remote.
2. In the unlikely event that your audio component cannot be operated after
performing the above procedures, please consult your audio components
operating guide.
3. The remote control will remember the codes you have programmed until the
batteries are removed from the remote control. After replacing the batteries
repeat the entire programming procedure as stated above.
4. If your audio component does not have a power function, the remote will issue
another obvious function that the audio component will respond to, such as
CD open/dose.
5. The default for AUDIO mode is AMP.
6. If you wish to control your receiver or miscellaneous audio equipment, you
must follow the remote programming procedure shown above. You may use
oniy the AMP button to proglam these codes, but note that this button may not
be used for more than one component.
7. The LAST button will act as your audio component's ENTER button if required.
DIRECTV
TV,_CA_ DSAT
VCR 0
U_ST
od5
GUIDE
CD
CiD
CD CD GD
1'8'
HITACHI
CLU.BI4Mp
.J
The remote may not
operate all models of all
brands,
27