Procedures - Hitachi RB 24EAP Instruction Manual

English
2. Set choke lever to CLOSED position. (Fig. 6)
RUN
(OPEN) _ \
/1
CLOSED JJ'
Fig. 6
3. Pull recoil starter briskly, taking care to keep the
handle in your grasp and not allowing it to snap
back. (Fig. 7)
Fig. 7
4. When you hear the engine want to start, return
choke lever to RUN position (open). Then pull
recoil starter briskly again.
WARNING
• Never start or run the engine inside a closed
room or building and/or near the inflammable
liquid. Breathing exhaust fumes can kill.
• Do not allow the rope to snap back in and
always hold the unit firmly.
NOTE
If engine does not start, repeat procedures from
2to 4.
5. After starting engine, allow the engine about 2-3
minutes to warm up before subjecting it to any
load.
* If the engine stops and is hard to restart
straightaway, allow it to cool before trying again.
Operating blower (Fig. 8)
© A low speed should be used to blow leaves and
dry grass.
© A medium speed should be used to clean wet
leaves and grass.
8
© A high speed should be used when moving
gravel, dirt or other heavy materials.
Fig. 8
WARNING
• Do not direct discharge of air toward people
or pet.
• The unit should be operated in a well
ventilated area.
• Never perform assembly or disassembly
procedures with engine running or serious
personal injury may result.
• Never touch muffler, spark plug, or other
metallic parts while engine is in running or
immediately after shutting off engine,
CAUTION
This blower has been designed and adjusted
to be used with all blowing pipes attached. It
must never be operated without the straight
pipe, and blow head.
Stopping (Fig. 9)
Decrease engine speed and run at an idle for a few
minutes, then turn off ignition switch and keep the
pressed until the engine comes to a complete stop.
OFF 7
\
Fig. 9