Download Print this page

Setting The Temperature; Fan Speeds - Haier HPAC99ER User Manual

Hide thumbs Also See for HPAC99ER:

Advertisement

Available languages

Available languages

NOTE: Wait for 24 hours to turn on air conditioner if the unit has been tilted for any
reason_ This is for the oils and the coolants to settle and level off_
1_Wait for 3 minutes before restarting the unit after a normal shut down so as to complete the
compressor cycle°
2. Use an ] ] 5v ] 5 amp outlet for the air conditioner. Do not use any other dectricd appliances on
this Jineor you may trip the fuse_Use a dedicated line for this air conditioner.
3_ Do not place the air conditioner in direct sunlight or close to any heating appliances_
ex. baseboard heaters, stoves, etc_
4_ Operate on a flat surface only_
5o Keep the unit free of any obstructures such as drapes, curtains, blinds, etc.
& Keep unit at least ] foot away from the walk
7_ Check and clean the filter once every week to get the highest efficiency_
NOTE: Do not use unit without filter_
8. If the unit is not being used for a long period of time remove the plug from the water drain pipe
and drain out any condensed water.
When turning on the unit first time after plugging it into an electrical outlet the unit will start in a low
fan cool mode_ The temperature read out on the LEDwill be the room temperature_ When
turning on the unit in regular usage it wiJl remember the last shut off setting_ if you want to operate
the air conditioner as a dehumidifier then adiust to dry mode_
Setting
The Temperature
To set the temperature press the + or the - key to raise or lower the temperature. The temperature can
be raised or lowered in the cod or dry
mode.
The temperature
cannot
be
adjusted
in the fan
mode.
Fan Speeds
There are 3 adjustable speeds in the cod and fan mode: Low, Medium & High. In the dry or
dehumidification mode the fan will only operate at low speed.
On/Off
Time Set
The air conditioner has a ] -12 hour on/off buibin timer. To delay start the unit from ] -12 hours at a
1 hour interval, simply press the time/set key and then press the + or- key to adjust the start time_
Note that the unit has to be plugged in to an electrical outlet for the timer to operate,
To auto shut-off the unit press the time/set key while the unit is running and then press the + or- key
to adiust the off time, The auto shut-off switch operates in all 3 modes: Cool, Dry & Fan,
NOTE: The temperature can be set between 60°F to 89°E
(7)

Advertisement

loading