Haier HI1MK Installation Instructions Manual page 10

4. Nowpush
the water supply line into the water valve inlet as far as it will
go. Slide the ferrule (sleeve) into the valve inlet and finger tighten the
compression nut onto valve. Tighten another half-turn with a wrench. Be
careful not to over tighten. Now, screw rear access panel that covers
compressor com )artment back in place. (See fig. # 1 2)
(Figure 12) ..........
Power cord Plastic water tubing
ii_;!i!i!i!
Coper water line
5. With the supplied steel clamp and hex head screw, secure the water
supply line to the rear panel of the refrigerator.
9