Table of Contents
Advertisement
XQB60-91AF
MANUAL
10/22/01
11:39
AM
_ge
21
iiiiiiiiiiiiiiiiii
¸ i ii ii ii ii
The
machine
beeps
and
display
shows
error
codes:
EO - This code is displayed
when the washer
door is not shut properly
during
the
delay start mode.
Close the washer
door properly
to continue,
E1 - This code is displayed
when the draining
is too slow.
The hose could be blocked,
cut or not properly
set.
Adjust
the hose properly
in order to drain.
Replace the new hose if it is cut.
E2 - This code is displayed
when the washer
stops running
during
the
Wash
>,-Spin _b-Rinse
mode.
The washer
door is not closed properly.
Close the top washer
door properly
to continue.
E3 - This code is displayed
when the washer
does not spin.
This is due to the washer
not leveled properly
or the tub is overloaded.
Adjust
the leveling
legs to balance
the washer.
Take out some clothes and
rearrange
clothes inside the tub.
[4 - This code is displayed
when incoming
water
flow is very slow.
This is due to not having
the faucet open properly.
Open the water faucet properly
to increase
the incoming
water flow.
[5 - This code is displayed
when incoming
hot water temperature
exceeded
over
140 Degree F/60
Degree C.
You must regulate
incoming
hot water temperature
as shown above.
You must
let the hot water cool down,
Once the hot water has cooled
down, you must
press "Start/Pause"
button to resume the cycle.
Problems
with
water:
• Not enough
water coming
out: Water faucet may need to be turned on fully.
Water
hoses may be tangled
up or wrinkled
up. Straighten
up hoses. Check water
level selection,
it may need to be readjusted.
• Water
leaks: This is due to not properly
installing
drain
hose or fill hoses. Your
home drain
may be clogged
or having
constant
water pressure.
You may need to
tighten
hoses, check the plumbing
or call a plumber.
• Water will not drain:
This is due to not installing
your drain
hose properly.
You
may need to connect
the drain
hose properly.
Check the position
of the drain
hose.
• There may be some water flowing
out of the drain
hose in the first use of the
machine,
This is due to the remaining
water left in the tub at the factory to inspect
and test the performance
of the unit to assure the best quality,
20
Advertisement
Table of Contents
