Before Setting Oven Controls; Removing, Replacing & Arranging The Oven Racks - Frigidaire GAS RANGE Use & Care Manual

Oven vent location
The oven vent is located at center rear of cooktop
below the control panel (See Fig. 1). When the oven is on,
warm air passes through this vent. This venting is
necessary for proper air circulation in the oven and good
baking results, Do not block the oven vent.
oven vent location
F Fig. 1 ]
Types of oven racks
__ flat handle
rack
oven rack
The flat oven rack or flat handle oven rack (some
models) may be used for most cooking needs,
The offset oven rack (some models) is designed to place
the base of the rack about 1/2 of a rack position lower than
normal. This rack design provides several additional
possible positions between the standard positions,
Removingr replacing & arranging racks
To remove - pull the rack forward until it stops. Lift up
front of rack and slide out.
To replace - fit the rack onto the guides on the oven walls.
Tilt the front of the rack upward and slide the rack back into
place.
Arranging - always arrange the oven racks when the oven
is cool (prior to operating the oven).
Always use oven mitts when using the oven. When
using the appliance, oven racks and cooktop will become
very hot which can cause burns.
Recommended rack positions by food type
Food type Position
(Fig. 2)
Broiling meats See broil
Cookies, cakes, pies, biscuits & muffins 2 or 3
Frozen pies, angel food cake, yeast, bread
and casseroles 1 or 2
Small cuts of meat or poultry 1 or 2
OJ K_y, JUriSt. Oi ii8iii i
Air circulation in the oven
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or
back of the oven cavity. Hot air must be able to circulate
around the pans and cookware in the oven for even heat to
reach around the food.