Cleaner Descriptions - Hoover SAVVY U8155-900 Owner's Manual

Push screws into holes on back of
handle (Fig. 1-6) and hose holder
(Fig. 1-7).
Tighten screws securely with a
Phillips screwdriver.
Cleaner description
u=J
Place hose on holder.
C
Remove label (C) from Custom
ControF Mswitch.
If label has come off during
assembly, make sure switch is in
OFF (down) position before plug-
ging into electrical outlet.
19
22_
18
21
The assembled cleaner will look like the drawing.
1. Handle 14. Nozzle control knob:
2. Custom ControF M power
switch
3. Custom ControF M
indicator
4. Tool cover
5. Dusting brush
6. Powered hand tool
slide knob to correct
setting for height of
carpet being cleaned.
15. Furniture guard
16. Headlight
17. Edge groomers
18. Hose
7. Furniture nozzle 19. Hose holder
8. Dirt cup 20.
9. Dirt cup handle
10. HEPA cartridge filter
11. Pre-filter
12. Final filter 21.
13. Three position handle 22.
release pedal: step on
lever to lower handle to
operating or low positions.
Cord hooks: wrap
cord around hooks for
storage. The top hook
rotates right or left for
easy cord release.
Extension wand
Crevice wand: stores
in wand.
Operate cleaner only at voltage specified on data plate
on bottom of cleaner.
This cleaner is intended for household use.
Polarized plug
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
4
Custom Control
TM
switch
Plug cord into electrical outlet.
CARPET setting - turns brush rolls ON, for
cleaning carpets and rugs. (Brush rolls will
automatically stop turning when handle is
raised to upright position.)
BARE FLOOR setting - turns brush rolls
OFF for cleaning hard surfact floors.
Brush roll automatic
shut-off
If something gets caught in the brush rolls,
the cleaner will automatically turn off.
Slide the 'Custom Control' switch to OFF
Unplug the cleaner.
Remove obstruction from brush rolls and
coninue cleaning.