Power Hand Tool Belt; Powered Hand Tool - Hoover UH70085 Owner's Manual

Powered Hand Tool {cont.)
Replacing Agitator Brushroll
How to Replace
Remove agitator
including end plates (A)
and discard,
lnspect belt to ensure
that it is in good
condition. If belt is
cracked, gouged or
broken, replace it (see
Following section).
lnsert brushro]] through
belt and position belt over gear teeth (B} on
brushroll,
To replace bottom plate,
insert the four tabs on
edge of bottom plate into
slots on front of toolo
Pivot bottom plate down
and snap closed.
With curved ends
down, slide end plates
(A) of brushroH into
slots (B}on tool.
Replace belt guard (A)
making sure not to
pinch brush bristles in
guar& Turn agitator,
to make sure it rotates
Freely.
Replace and tighten
screws.
Agitator Brushroll: What to Buy
When purchasing a new Powered Hand Tool
Agitator BrushroH, ask for HOOVER ® part No,
48414-088_
Belt Replacement
The powered hand tool belt is designed to last a long time and is not normally replaced° However, if
the belt is cracked, gouged or broken, it should be replace&
Inspecting the Replacing the
Belt Belt
The belt can be seen
through the
top of
the
nozzle or by removing
thebottom
plate and
belt guard (Figs, 4-23
to 4-24).
Grasp turbine (A) and
pulI firmly to remove,
Remove belt from
turbine pulley (B),
RepIace with new belt.
B
With flat sides of
turbine retainers (A)
pointing down, slide
retainers into grooves
[B} in tool housing and
snap into
placer
Replace brushroll, belt
guard, and bottom plate
as described in _igs.
4-25 through 4-28,
Powered Hand Tool Belt: What to Buy
When purchasing a new Powered Hand Tool
Belt, ask for HOOVER part No, 38528-O3Z
13