Box Functions - Hitachi 27Cx4B Operating Manual

USING THE GENIUS REMOTE TO CONTROL CABLE
BOX FUNCTIONS
OPERATING THE PRE-CODED FUNCTION FOR YOUR CABLE BOX.
This Genius Remote is designed to operate different types of cable boxes. You must first program the Genius Remote
to match the remote system in your cable box. (Refer to Table 2 on page 32 or Table 4 on page 33.)
1. Set the MULTI-PAGE select switch to"CATV."
2. Set the USE/LEARN mode select switch to "USE." (For CLU-851GR only)
3. Turn ON your cable box.
4. Aim the Genius Remote control at the front of your cable box.
5.
While holding down the SELECT button, press the button that matches our cable box as shown on page 32 or page
33. Continue to hold down both buttons. The channels of the cable box will begin changing when the correct button
is pressed. When this occurs, the Genius Remote Control is programmed for your cable box. If the cable box
channels do not change after 5 seconds, try a different Genius Remote button.
6.
®
®
®
Release both buttons when the cable box starts to change channels. The Genius Remote will now control your cable
box.
o o
POWER READY LEARN
NOTES:
1. If your cable box cannot be operated after per-
forming the above procedures, this means that
your cable box codes have not been precoded
into the GENIUS REMOTE. Please store your
cable box codes in memory by using the USER
mode. (Refer to page 34.)
The GENIUS REMOTE CONTROL will remem-
ber the codes you have programmed in until the
batteries are removed from the GENIUS RE-
MOTE CONTROL. After replacing the batteries,
repeat the entire programming procedure stated
above.
2.
PRECODED FOR CABLE BOX
These buttons always transmit the chosen precoded
CATV codes.
SELECT BUTTON
This is for setting up the cable box's Pre-code.
O-
EXCLUSIVE TV BUTTONS
These buttons are for operatingthe TV.
I II II II I
I II II I ISELECTI
.................. _01_"
MENU
GENIUS REMOTE
CLU-851GR
J
31