Antenna Connections; Cable Tv Connections - Hitachi L40C205 Owner's Manual

Antenna connections
If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you
are using a Cable TV service, see Cable TV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable)
Antenna
Jack
75 ohm
Coaxial i
Cable
Cable TV connections
This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some
cable companies offer "premium pay channels" where the signal is scrambled. Descrambling these signals for normal
viewing requires the use of a descrambler device which is generally provided by the Cable TV company.
For subscribers to basic Cable TV service
For basic Cable "FV service not requiring a Converter/Descrambler box, connect the
75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV.
75 ohm
Coaxial Cable
For subscribers to scrambled Cable "IV service
If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial
Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler
box to the Antenna Jack on the TV, Follow the connections shown below. Set the TV to the output channel of the Converted
Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels.
incoming 75 ohm Cable TV Cable t' I
Converter/
Descrarnbler
t
75 ohm Cable to TV
Antenna
Jack
_RiCAB_
For subscribers to unscrambled Cable TV service with scrambled premium channels
If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a
Converter/Descrambler box, you may wish to use a signal Splitter and an AiB Switch box (available from the Cable TV company
or an electronics supply store). Follow the connections shown below. With the switch in the "B" position, you can directly tune any
nonscrambled channels on your TV. With the switch in the "A" position, tune your TV to the output of the Converter/Descrambler box
(usually channel 3 or 4) and use the ConvertedDescrambler box to tune scrambled channels.
r Incoming
_ C°nverteri h_
75 ohm Descrambler Antenna
Cable TV Jack A_RiCABLE
Cable 75 ohm Cable to TV
:- litter A/B Switc
12