Download Print this page

Advertisement

About the water softener system.
Service: Manually Advance Recharge Check
NOTE:The
control
display
must
show a steady
time
(not flashing).
I. Press the RECHARGE @ button
and
hold in
for three
seconds.
RECHARGEbegins to flash
as the water sottening
system
enters
the fill
cycle of recharge.
Remove
the brinewell
cover and,
using a flashlight,
observe
fill
water
entering
the brine
tank. If water
does
not enter
tile tank, look tot an obstructed
nozzle,
venturi,
fill flow plug or brine
tubing.
See Care and Cleaning of the Water Softener
System section.
2. After
obser\ing
fill, press
tile RECHARGE @
button
to move tile water softening
s)_stem
into brining.
A slow flow of water
to the drain
will begin.
Veritk' brine
draw fl'om tile brine
tank by shining
a flashlight
into the brinewell
and
observing
a noticeable
drop
in the liquid
level over an extended
period
of time.
NOTE: Be sure a salt bridge
is not preventing
water fl'om contacting
salt. See Care and
cleaning
of the water softening
system
section.
ff the water softening system does not draw brine,
check:
i_i' nozzle
and/or
venttlri
dirty
or
deti_ctive.
N defective
nozzle
and venturi
seal.
_: nozzle
and venturi
not seated
propedy
on gasket.
_: other
inner
wive
defect
(rotor
seal, rotor
and
disc, wave washe_;
etc.).
::Ji:: restricted
drain
(check
drain
fitting
and
hose).
NOTE:
If water system
pressure
is low, an
elew_ted
drain
hose may cause
back pressure,
stopping
brine
draw.
3. Again,
press
tile RECHARGE @ button
to moxe
the water
sottening
system into backwash.
I,ook for a fast flow of water fl'om
tile drain
hose. A slow flow indicates
a i)lugged
top
distributor,
backwash
flow plug
or drain
hose.
4. Press tile
RECHARGE@
button
to Inove tile
water
sottening
s):stem
into tast rinse.
Again
look for a tast drain
flow. Allow the water
sottening
system
to rinse
for a few minutes
to flush
out any brine
that mav remain
in
the resin
tank fl'om
the brining
cycle test.
5. To return
tile water sottening
system
to
set\ice,
press
tile RECHARGE @ button.
18

Advertisement

COMING SOON

Comments to this Manuals

Symbols: 0
Latest comments: