GE JTD910 Owner's Manual page 12

Installation of the warming drawer.
Read these instructionscompletely and carefully.
Advance Planning
N The wmaning drawer may be in.smiled directly
into awall or wall oven cabinetly.
N The wanning drawer may Ix' installed below a
countenop, a single or double oven and side by
side using 2 drawei ,'s,
N When installing warming drawer with a cooktop
allow a 2" minimum from [x)ttom ofa c(×)kt_p
burner box to top of cutout.
N Etecuical power cord is locamd on the fight
side of the wanning drawer. Locate the outlet
wiflain reach of fhe 56" long power cord in
adjacent cabinet, within 42" of the fight side
or 16" @ore the left side of the cutout.
A reces_d receptacle can be installed on
the right side of tlae cufout, 7" maximum
@ore the back of the cabinet.
GroundingtheAppliance
IMPORTANT--(Please read carefully)
FOR PERSONALSAFETE THISAPPLIANCE
MUST BE PROPERLYGROUNDED.
Do not use an extension cord or adapter plug
wifh fl_isappliance, leollow National Electrical
codes and ordinances.
3_is warming drawer must be supplied wifh 120V,
60Hz, and connecmd to an individual, properly-
ga'()unded branch circuit, and protected by a 15
or 20 amp circuit breaker or time delay fuse.
N A properly grounded 3-prong receptacle
should be locamd within reach of the drawer's
56" long Ix)wer cord,
_---Recessed receptacle
7" max fromrear
onrightside
Drill 1½"* holefor
powercordfor left
or rightsideoutlet
location
IMPORTANT--(Please read carefully)
@1*)cate the receptacle in an adjacent cabinet.
--wifhin 42" of the iight side or,
--wifhin 16" of fhe left side or
--A recessed receptacle may be located on tlae
right side of the cutout, 7" maximum from the
back of tlae cabinet. In flais location, the excess
Ix)wer cord should be coiled m flae right side
of the unit using the cord clip provided.
3_e Ix)wer cord of this appliance is equipped with
a 3-prong (gTounding) plug flaat males wifh a
stand_d 3-prong grounding wall receptacle to
minimize fhe IX)ssibility of electric shock. The
cusfomer should have the wall receptacle and
circuit checked by a qualified elecuician to make
sure the receptacle is properly grounded and has
the correct polarity.
@Where a standard 2-prong wall receptacle is
encounmred, it is tlae per_)nal responsibility
and obligation of fhe customer fo have it
replaced with a properly grounded 3-prong
wall receptacle.
Do no_ under any circumstances, cut or remove
the third (ground) prong from the power cord.
DO NOT USEAN EXTENSION CORD.
12