The Test Button - Axis 5900 User Manual

The Test Button

Section 13 The Test Button
Printing a Test Page
Note:
Printing a Parameter
List
Performing a Factory
Default
Note:
134
The test button is located on the front right hand side of the AXIS 5900
and is used for:
• Printing a test page to check the connection to the printer.
• Printing a parameter list to see the print server's current settings.
• Performing a Factory Default of the print server.
If you want to change any of the parameters, use one of the methods
described in "Management and Configuration" on page 92.
Press the test button once to print a test page. The test page contains
basic information about the AXIS 5900. It is recommended that you print
a test page every time you connect the print server to a printer.
The test page is printed on LPT1 by default. If you want to print the test page on LPT2, you
should set the Internal Printout Destination parameter to LPT2 from the internal Web pages
under Admin | General Settings | General.
Press the test button twice to print a parameter list showing the current
AXIS 5900 settings. This list provides comprehensive details of all the
parameters and their current status. Refer to "The Parameter List" on page
142.
1. Remove the external power supply to switch off the print server.
2. Press and hold down the test button while you reconnect the external power
supply.
3. Continue to hold down the test button until the Network indicator remains
constantly lit. This should take about 20 seconds.
4. Restart the print server by disconnecting and reconnecting the external
power supply.
The Axis Network Print Server is now reset to factory default settings.
A Factory Default will reset all AXIS 5900 parameters and settings to their default values,
except:
• Installed certificate
• Private key
AXIS 5900 User's Manual