Installation Instructions - GE GSH25JFPACC Owner's Manual And Installation Instructions

Installation
Instructions
Refrigerator
Models 20, 22, 25
Questions?Call 800.GE.CARES (800.432.2737) or Visit
our Website at:
www.GEAppliances.com
In Canada, call 1.800.361.3400 o r VisitourWebsite at:www.geappliances.ca
I
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - gave t heso
instructions for local inspector's use.
• IMPORTANT - Obsorvo all
governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer
- Keep
these instructions
1or fllttlre reference.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Completion time - Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(on some models)
If the refi'igerator has an icemakm; it will have to be
connected to a cold water line. AGE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost fi'om your dealm;
by visiting our Website at www.GEAppliances.eom
(in Canada, at www.geappliances.ea) or fi'om Parts
and Accessories, 800.626.2002.
REFRIGERATOR LOCATION
• Do not install tile refiigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances tbr ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
A door clearance of 3/4" (19 rnm) is needed for a 90 °
door opening which provides better access to the food
storage area.
ROLLERS
The rogers have 3 purposes:
• Rollers adjust so the door closes easily when opened
about halfu_y.
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
Rollers allow you to move the refrigerator a_a_yfrom
the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting scre,a_ dockwise to raise the
refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8" hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the kuottom of the cabinet. Push
foYward until grille snaps into place.
14