GE DBLR333 Owner's Manual page 18

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk
of fire or explosion, electric shock, or to prevent property damage, personal injury, or
death.
• Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
• Installation end service must be
performed by o qualified installer,
service agency or the gas supplier.
WHAT TO DO IF YOU SMELL GAS:
[] Do not try to light a match, or
cigarette, or turn on any gas or
electrical appliance.
[] Do not touch any electrical switch;
do not use any phone in your building.
[] Clear the room, building or area of all
occupants.
[] Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions carefully.
[] If you cannot reach your gas supplier,
call the fire department.
California Safe Drinking Water and Toxic Enforcement Act
This act requires the governor of California to publish a list of substances known to the state to cause cancer,
birth defects or other reproductive harm and requires businesses to warn customers of potential exposure to
such substances.
Gasappliances can cause minor exposureto four of these substances,namely benzene,carbon monoxide,
formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LPfuels.
Properly adjusted dryers will minimize incomplete combustion. Exposureto these substances can be
minimized further by properly venting the dryer to the outdoors.
%
PROPERINSTALLATION
This dryer must be properlg installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting ge.com or bg calling 800.GE.CARES (800.432.2737).
[] Properly ground dryer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
[] Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather, which could cause permanent damage
and invalidate the warranty.
[] Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
[] Removeall sharp packing items and dispose of
all shipping materials properly.
Exhaust/Ducting
]Gas dryers MUST be exhausted to the outside.
]Use only rigid metal 4" diameter ductwork inside
the dryer cabinet. Use only rigid metal or flexible
metal 4" diameter ductwork for exhausting to the
outside. USE OF PLASTIC OR OTHER
COMBUSTIBLE DUCTWORKCAN CAUSE
A FIRE.PUNCTURED DUCTWORKCAN CAUSEA
FIREIF IT COLLAPSES ORBECOMES OTHERWISE
RESTRICTED IN USEORDURINGINSTALLATION.
For complete details,follow the Installation
Instructions.