GE JGP337 Owner's Manual And Installation Instructions page 23

Built-in gas cooktops
Hide thumbs Also See for JGP337:
Table of Contents

Advertisement

Installation
Instructions
Installation---Electrical
Connections
Ib---4-1
usage situations where
i
i
appliance power cord will be
disconnected infrequently.
For 15 amp circuit only. Do not use an adaptor
on a 20 amp circuit. Where local codes permit,
a TEMPORARY
CONNECTION
may be made
to a properly grounded two-prong wall
receptacle by the use of a UL listed adaptor
available at most hardware stores. The larger
slot in the adaptor must be aligned with the
large slot in the wall receptacle to provide
proper polarity in the connection
of the
power cord.
Insure proper ground
'l _" II andfLren_oCOn%ection
Align large
prongs/slots
Temporary Method
(Adaptor plugs not permitted
in Canada)
CAUTION:
Attaching
the adaptor
ground
terminal
to the wall
receptacle
cover screw does not
ground
the appliance
unless the
screw is metal, and not insulated,
and the wall receptacle
is grounded
through
the house wiring. The
customer
should have the circuit
checked
by a qualified
electrician
to make sure the receptacle
is
properly
grounded.
When disconnecting
the power cord from the
adaptor, always hold the adaptor with one
hand. If this is not done, the adaptor ground
terminal
is very likely to break with repeated
use. Should this happen,
DO NOT USE the
appliance
until a proper ground
has again
been established.
Usage situations
where appliance
power
cord will be disconnected
frequently.
Do not use an adaptor
plug in these situations
because
disconnection
of the power cord
places undue strain on the adaptor and leads
to eventual failure of the adaptor ground
terminal.
The customer
should have the two-
prong receptacle
replaced
with a three-prong
(grounding)
receptacle
by a qualified
electrician
before using the appliance.
23

Advertisement

Table of Contents
loading

Table of Contents