GE ASH08 Owner's Manual And Installation Instructions page 5

GEAppliances.com
When the air conditioner is turned on, it will Lights next to the touch pads on the air conditioner
automatically start in the setting last used. control panel indicate the selected settings.
COOL Mode
Use the COOL mode widl HIGH(F3), MED (F2)or
LOW (F1) fan for cooling. Use the INCREASE •/
DECREASEV pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. 'i11e compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and tim indoor air will bccome w-armen
NOTE: If the air conditioner is off and is then tumed on
while set to COOL, ff will take approximately3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
ForNormal Cooling - Select the COOLmode and
HIGH(F3)or MED(F2)tan wida a middle set
temperature.
For Maximum Cooling - Select the COOL mode
mad HIGH(F3) Fan with a lower set temperature.
ForQuieter& NighttimeCooling- Select the
COOLmode and LOW (F1)fan with a middle set
temperature.
NOTE: ff you switch from a COOL setting to OFFerto
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use the FAN at HIGH (F3), MED (F2)or LOW (F1) to
provide air circula6on and filtering without cooling.
Since fan only" settings do not provide cooling, a
temperature setting will not be displayed.
VentControl
_ilae vent control is located on the inside of the
air louvers in the lower right corner.
When set at CLOSE,only"the air inside the room
will be circulated and conditioned. When set at
OPEN,some inside air is exhausted outside.
I f
t/"
v
To open the vent, push the lever to the right,
To close it, push it to the left.
Air Direction - Up and Down
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
OR
5