Glass Control Panel; Packaging Tape - GE JP328 Owner's Manual & Installation Instructions

Careand cleaning of the cooktop.
Be sure electrical power is off and aft surfaces are cool before cleaning any part of the cooktop.
How to Remove Packaging Tape
To assure no dmnage is done to the finish
(ff the product, the satest way to remove
the adhesive left fl'om packaging tape on
new appliances is an application of a
household liquid dishwashing detergent,
mineral oil or cooking oil.
Apply with a soft clofl_ and allow to soak.
_._pe dry and then apply an appliance
polish to thoroughly clean and protect
the surti_ce.
NOTE: Theplast/? tape must be removed from all
chrome trim. It cannotbe removed if it/s baked on.
Glass Control Panel
Theglass control panel on your cooktop has been
temperad to withstand sudden temperature
changesduringcooking. Giveit the normal care
you wou/dgive any glass material
_,_]file it is impact-resistant, avoid
scratching it to prevent it fl'om shattering.
If the glass is hot, wipe up spills with a dry
cloth or paper towel. _,\]_en the surfi_ce
has cooled, wash, rinse and (h T it.
Mternately; when the glass is cool, spray it
with glass or window cleane_: Avoid the
use of cleaning powders or hmsh
abrasives that may scratch the stm'i_ce.
Moldedril:
Spring
clip
Clear gmnve
Control Knobs
Thecontrol k nobsmaybe removed foreasier
cleaning.
Before removing the knobs
fl)r
cleaning, please note that the knobs
are in the OFFposition. When
replacing the knobs, check the OFF
position to insm'e proper placement.
The knob has a groove in each side. The
groove on one side has a spring clip. The
other groove is clea_: Check the inside of
the knob and find the molded rib.
X4ash knobs in soap and water but do not
soak. Avoid getting water down into the
knob stem holes.
Replace the knob by fitting the molded
rib inside the knob into the clear groove
on the stem.