GE RAK348R1 Owner's Manual page 8

Thermostat programming (cont.).
Step One
Press the PROGRAM button to put the thermostat into the programming mode. The displag
will blink all of the dag-of-the-week icons. Pressing the UP or DOWN button will toggle between
the weekdag icons and the weekend icons. Ensure the displag is blinking the one gou want to
program. Press HEAT/COOL
Step Two
Next, the morning period will blink. Use the UP or DOWN button to toggle through Horning,
DQ9, Evening or Night, stopping at the period 9ou want to program. Press HEAT/COOL.
Step Three
Next, the hour of the dag will blink. This is the starting hour of the period gou have selected.
Use the UP or DOWN button to change the selected hour start time. Press HEAT/COOL.
Step Four
The minute of the dug will blink next. This is the starting minute in the hour Use the UP or
DOWN button to change the minute digits to the desired setting. (Note that minutes change
in five-minute increments.) Press HEAT/COOL
Step Five
The desired set point will now be blinking. This is the temperature gou want the thermostat to
go to at the time of dag gou hove selected. Press the UP or DOWN button to change to the
desired set point temperature. Press HEAT/COOL.
This completes the programming of the first period of the dag.
Step Six
If gou started with the Homing time period, the next period, Dag, will now be blinking. Follow
steps two, three, four and five for each period gou wish to program.