Advertisement
Step 2: Assemble Three "A"
Gangs
Tines used in this step:
two left-curved tines
followed by
two right-curved tines
A. Place two left-curved tines
onto the template so that the
tines cover the outlines of tines
#1 and #2 as shown in Figure 15.
The tips of the tines point
Cutting
Edge
Figure 15: Assembly of an "A" gang.
Step 3. Assemble One "B" Gang
Tines used in this step:
two right-curved tines
followed by
two left-curved tines
downward (overhanging the
sides of the box).
B. Place three bolts through the
holes as shown in Figure 16.
C. Place two right-curved tines
(shown in Figure 16) onto the
bolts so that the tines cover the
outlines of tines #3 and #4.
These tines are opposite each
other on top of the tines already
in place. The tips of these tines
face upward as shown.
NOTE: Do not insert a bolt
through the fourth hole.
Cutting
Edge
Figure 16: Insert bolts.
A. Position the box (with the
attached template) in front of
you as was done when
assembling the "A" gangs.
B. Place two right-curved tines
(shown in Figure 17 on Page 10)
onto the template so that the
tines cover outlines of tines #3
and #4. The tips of these tines
point upward.
D. Add lockwashers (not used
with Custom tines) and nuts to
the three bolts and barely tighten
the nuts (just so they do not fall
off the bolts).
E. For future identification
when installing the gangs on the
holders, use chalk or crayon to
mark each gang with an "A."
F. Repeat Steps A through E to
construct two more "A" gangs.
Set these gangs aside until you
install them in Step 4 on
Page 10.
Cutting
Edge
C. Place three bolts through the
holes shown in Figure 18 on
Page 10.
D. Place two left-curved tines
(shown in Figure 18) onto the
bolts so that the tines cover the
outlines of tines #1 and #2.
These tines are opposite each
other on top of the tines already
in place. The tips of these tines
point downward (overhanging
the sides of the box).
Cutting
Edge
9
Advertisement
