Nautilus Be strong NS 200X Assembly Manual page 11

STEP 3
16
20
Step 3 Components:
# Component
15 Roller Bar
16 Press Arm
17 Press Arm Support Assembly
18 Press Arm Handle - Right
19 Press Arm Handle - Left
20 Foam Roller 8"L
21 Roller End Cap
22 Plastic Washer
25 Press Arm Pivot Shaft
26 Press Arm Support Shaft
57 Button Head Allen Screw 3/4"L
80 3/8" Curved Washer
65 Set Screw 5/16" x 1/4"L
ASSEmBLY
65
17
26
25
57
80
18
19
21
22
15
Procedure:
Qty
A. Attach Press Arm Support Assembly (17) to the Top Frame using the
Press Arm Support Shaft (26). Align Shaft and tighten the 4 set screws
1
(65) shown.
1
B. Remove Pop Pin from Press Arm (16). Attach Press Arm (16) to Press Arm Support
1
Assembly (17) using the Press Arm Pivot Shaft (25), making sure that the shaft is
1
centered. Secure by tightening the two set screws (65) firmly. Attach Pop Pin.
1
Tighten using adjustable wrench.
2
C. Attach Press Arm Handles (18) (19) using hardware shown. Tighten
2
hardware firmly.
2
D. Slide Roller Bar (15) through the Leg Extension Assembly. Either hole
1
can be used depending on best fit for user.
1
E. Slide a Plastic Washer (22) followed by a Foam Roller (20) on to roller
4
bar (15). Press the Roller End Cap (21) firmly into the Roller Bar (15).
4
Repeat for the opposite side
6
Nautilus NS00X
11