Nautilus Be strong NS 200X Assembly Manual page 10

STEP 2
49
7
50
3"L
50
3"L
Step 2 Components:
# Component
5 Calf Raise / Low Pulley Frame
6 Top Stack Support Frame
7 Cable Housing
9 3 inch Backing Plate
12 Floating Pulley Bracket
14 3½" Pulley
41 Cable #1 - Low Row (136.5")
49 Hex Bolt 3/8" x 3 1/4"L
50 Hex Bolt 3/8" x 3"L
54 Hex Bolt 3/8" x 2"L
58 1/2" Flat Washer
59 3/8" Flat Washer
60 1/2" Lock Nut
61 3/8" Lock Nut
10
9
3 1/4"L
Procedure:
a. Attach Top Stack Support Frame (6) to Top Frame using 3" Backing
Qty
1
B. Attach Floating Pulley Bracket (12) to Top Stack Support Frame (6)
1
1
1
c. Attach Cable Housing (7) to Main Base Frame using hardware shown.
1
2
1
2
D. Install Cable #1 (41) through Calf Raise / Low Pulley Frame (5).
6
2
1
20
1
10
e. Attach Calf Raise / Low Pulley Frame (5) to Main Base Frame and
ASSEmBLY
60
6
50
3"L
59
61
5
Plate (9) and the hardware shown. Tighten hardware firmly.
using hardware shown. Do not tighten.
Tighten hardware firmly.
Note: If an exercise attachment such as a leg press is used, do not
install Cable Housing (7).
Feed the looped end of the cable (without ball) through the foot plate
side of the Calf Raise / Low Pulley Frame (5). Attach two 3 ½" pulleys
(14) using hardware shown, making sure that the cable runs in the
groove on the low side of the pulley. Final installation of the cable will
be completed on Step 8. NOTE: Make sure that the cable is NOT
wrapped around the cable stop.
Rear Frame using hardware shown. Tighten hardware firmly.
58
12
136.5" (3470mm)
41
14
54
2"L
14
54
2"L