Operation; Main Unit Operation - Sharp Plasmacluster FP-N25CX Operation Manual

OPERATION

MAIN UNIT OPERATION

AUTO SILENT LOW HIGH
DETERMINING THE BASE IMPURITY RATE
For the first 2 minutes after the power plug is inserted into the wall outlet, the unit will
check the conditions of the air. If operation is set to ON during this time, the CLEAN-
SIGN LIGHT will alternately flash in green, orange and red.
The unit will start operating when the MODE-ON/OFF Button is pressed.
To change operating modes, press the MODE-ON/OFF Button until the desired control
is activated.
AUTO operation
The fan speed is automati-
cally switched (HIGH, LOW,
SILENT) depending on the
amount of odor in the air. The
sensor detects the odor for
efficient air purification.
SILENT operation
The unit will operate quietly
using minimal air intake.
LOW operation
HIGH operation
MODE-ON/OFF Button
QUICK AUTO POLLEN CLEAN SIGN
Stop
E-12
Main Unit Controls
• AUTO
• SILENT
• LOW
• HIGH
• QUICK AUTO
• POLLEN
OFF TIMER h
Plasmacluster
Plasmacluster Indicator Light
POLLEN mode operation
The unit will operate at High fan
speed for 10 minutes, then will al-
ternate between LOW and HIGH.
10 minutes: High fan speed
20 minutes: Low fan speed
20 minutes: High fan speed
QUICK AUTO operation
The unit will operate at High fan
speed for 10 minutes, then will
operate in AUTO operation.
10 minutes: High fan speed
AUTO operation